Skip to main content
DMV Test Free

Alabama CDL — General Knowledge practice

Speed & Space Management

Choosing a safe speed, keeping a space cushion, adjusting for weather and traffic, and understanding stopping distance.

Content reviewed against official driver handbooks · July 7, 2026

20 questions · pass with 16 correct. You get instant feedback and an explanation after every answer.

Study questions with answers

12 sample Speed & Space Management questions with the correct answer, a short explanation, and the official handbook reference. Read through them, then take the quiz above.

  1. 1. If your vehicle begins to hydroplane, you should:

    Correct answer: Release the accelerator and let the vehicle slow down

    During hydroplaning, ease off the accelerator (and push in the clutch if needed) rather than braking, which can cause a skid.

    Source: Alabama CDL Manual - Section 2.6.2 (Matching Speed to the Road Surface)

  2. 2. Of all the space around your vehicle, the most important space to manage is:

    Correct answer: The space ahead of you

    You need room in front more than anywhere else because that is the space you can use to avoid what happens ahead.

    Source: Alabama CDL Manual - Section 2.7.1 (Space Ahead)

  3. 3. When a heavy load slows you going uphill and others tailgate, the best move is to:

    Correct answer: Stay in the right lane where you can

    If a heavy load holds you back on a grade, keeping to the right lets faster traffic get around you safely.

    Source: Alabama CDL Manual - Section 2.7.2 (Space Behind)

  4. 4. If you double your speed, what happens to your braking distance?

    Correct answer: It becomes about four times longer

    Going from 20 to 40 mph makes both the impact and the braking distance roughly four times greater.

    Source: Alabama CDL Manual - Section 2.6.1 (Stopping Distance - Effect of Speed)

  5. 5. Hydroplaning can begin at speeds as low as:

    Correct answer: 30 mph when a lot of water is present

    With enough standing water, tires can lose contact and hydroplane at speeds as low as 30 mph, especially with low pressure or worn tread.

    Source: Alabama CDL Manual - Section 2.6.2 (Matching Speed to the Road Surface)

  6. 6. In a roadway work zone, the number one cause of injuries and deaths is:

    Correct answer: Speeding traffic

    Speeding is the leading killer in work zones, so obey the posted limits and slow further when workers are near the road.

    Source: Alabama CDL Manual - Section 2.6.7 (Roadway Work Zones)

  7. 7. Total stopping distance is made up of which three parts?

    Correct answer: Perception distance, reaction distance, and braking distance

    The distance to stop is the sum of how far you travel while perceiving the hazard, reacting to it, and then braking.

    Source: Alabama CDL Manual - Section 2.6.1 (Stopping Distance)

  8. 8. Reaction distance refers to how far the vehicle travels:

    Correct answer: After your brain recognizes the hazard but before you push the brake

    Reaction distance is the ground covered while you move your foot to the brake - roughly 61 feet at 55 mph for an average driver.

    Source: Alabama CDL Manual - Section 2.6.1 (Stopping Distance)

  9. 9. As you drive through a long construction zone, you should watch the speedometer because:

    Correct answer: Your speed can creep up without you noticing

    Speed tends to drift upward over a long work zone, so checking the speedometer keeps you at the posted limit.

    Source: Alabama CDL Manual - Section 2.6.7 (Roadway Work Zones)

  10. 10. On a slippery road, the space you need to stop:

    Correct answer: Increases well beyond what dry pavement requires

    Reduced traction on wet or icy roads means you must allow much more following and stopping space than on dry pavement.

    Source: Alabama CDL Manual - Section 2.7.1 (Space Ahead)

  11. 11. Why does a vehicle's speed tend to increase on a downgrade?

    Correct answer: Gravity pulls the vehicle downhill

    On a long downgrade, gravity works to accelerate the vehicle, so drivers must choose a safe speed and low gear ahead of time.

    Source: Alabama CDL Manual - Section 2.6.6 (Speed on Downgrades)

  12. 12. Why should you be concerned about the space overhead?

    Correct answer: Hitting overhead objects like bridges or wires can damage the vehicle

    Low bridges, signs, and wires can be struck by a tall vehicle, so knowing your height and watching overhead clearance matters.

    Source: Alabama CDL Manual - Section 2.7.4 (Space Overhead)

Practice Speed & Space Management in another state

Every Alabama question is written from the official Alabama driver handbook and checked against its current edition. DMV Test Free is a free, independent study resource — not affiliated with any DMV or government agency. About DMV Test Free